Keri-systems RPB-200 Manuale Utente Scaricare il pdf (Pagina 2)

RPB–200: RF Receiver

1530 Old Oakland Road, Suite 100 01825-200 Rev. B

San Jose, CA 95112 USA

(800) 260-5265 (408) 451-2520 FAX (408) 441-0309

Web: http://www.kerisys.com E-mail: [email protected] Page 2 of 8

Quick Start Guide

RPB–200

2.0 Connections

The connection between the PXL controller and the RPB-200 is made through a 7 conductor, shielded, stranded, AWG

24 wire cable (such as Belden 9537 or a larger gauge).

Before running a cable to the RPB-200 you must drill a 1/4 inch diameter hole in the case of the RPB-200 to

accommodate the cable. After the cable has been connected to the RPB-200, the cable/hole can be sealed with a

silicone/RTV type sealer.

2.1 Connecting to the RPB-200

The cable connects to the terminal strip on the RF receiver board, pins 1 through 8 (excluding pins 3 and 6). The cable

shield is not connected at the RPB-200.

2.2 Connecting to the PXL-250W

For an "A" reader connection, the cable connects to TB5 pins 1 through 7 (excluding pin 2). For a "B" reader

connection, the cable connects to TB6 pins 1 through 7 (excluding pin 2).

RPB–200 Cable Connections Connecting to the PXL–250W at TB5/TB6

Figure 2: RPB–200 Connections Figure 3: PXL–250W Connections

Pin # Function Wire Color Pin # Function Wire Color

1 Ground Black 4 Ground Black

–– –

4 Shield Silver

2Power Red

3 12V Power Red

3 no connection –

2not used –

4 Red LED Brown

6 Red LED Brown

5 Green LED Orange

6 Yellow LED –

–– –

7 Data 1 White

8 Data 0 Green

1 Data 0 Green

1 2 3 4 5 6 7 8

Nessun commento

Keri-systems RPB-200 Manuale Utente Pagina 2